噴涂料生產設備系類

STR-NKP-1型輸送管道內部靜電噴涂器  Spraying machine for piping inner wall

◆不適用依據 Applicable scope

選廣泛用于孔眼及大中小型通道的壁內外墻乳膠漆，它是用無氣噴外墻乳膠漆機輸送帶來的超高壓外墻乳膠漆，采用精制的管口，使外墻乳膠漆吸霧后立即轉變成高音喇叭形（園球形、空腔），不規則地噴在通道內外表面，因而完成通道的外墻乳膠漆。 NKP-1型通常適用性于Ф50-Ф300mm的管材，藝術涂料用戶粘度不準超過80秒（4號福特杯）。比如水性涂料107硅橡膠粘度不低于80秒，需要溶液配制。NKP-1型根本上中受排水管直徑受到限制，但合適不長而15米。

Apply YuXiaoKong and medium pipe wall coating, it is to use it without gas transmission to high voltage coating, through the special nozzle, to make the paint spray directly formed after flared (garden tapered, hollow), evenly spray in the pipe inner surface, so as to realize the pipe coating. NKP-type 1 is mainly used in Ф 50-Ф 300 mm pipe, coating viscosity shall not be higher than the 80 seconds (4 ford cup). If the paint is higher than 80 seconds, viscosity should be diluted solvent. NKP-type 1 basically from piping length restrictions, but had better not longer than 15 meters.

安裝方框圖 Installation to which